Wyniki wyszukiwania

Filtruj wyniki

  • Czasopisma
  • Autorzy publikacji
  • Słowa kluczowe
  • Data
  • Typ

Wyniki wyszukiwania

Wyników: 3
Wyników na stronie: 25 50 75
Sortuj wg:

Abstrakt

The Antarctic Peninsula region has experienced a recent cooling for about 15 years since the beginning of the 21st century. In Livingston Island, this cooling has been of 0.8°C over the 12-yr period 2004–2016, and of 1.0°C for the summer average temperatures over the same period. In this paper, we analyse whether this observed cooling has implied a significant change in the density of the snowpack covering Hurd and Johnsons glaciers, and whether such a density change has had, by itself, a noticeable impact in the calculated surface mass balance. Our results indicate a decrease in the snow density by 22 kg m-3 over the study period. The density changes are shown to be correlated with the summer temperature changes. We show that this observed decrease in density does not have an appreciable effect on the calculated surface mass balance, as the corresponding changes are below the usual error range of the surface mass balance estimates. This relieves us from the need of detailed and time-consuming snow density measurements at every mass-balance campaign.
Przejdź do artykułu

Abstrakt

The article is devoted to the method facilitating the diagnostics of dynamic faults in networks of interconnection in systems-on-chips. It shows how to reconstruct the erroneous test response sequence coming from the faulty connection based on the set of signatures obtained as a result of multiple compaction of this sequence in the MISR register with programmable feedback. The Chinese reminder theorem is used for this purpose. The article analyzes in detail the various hardware realizations of the discussed method. The testing time associated with each proposed solution was also estimated. Presented method can be used with any type of test sequence and test pattern generator. It is also easily scalable to any number of nets in the network of interconnections. Moreover, it supports finding a trade-off between area overhead and testing time.
Przejdź do artykułu

Abstrakt

Achieving control of coating thickness in foundry moulds is needed in order to guarantee uniform properties of the mould but also to achieve control of drying time. Since drying time of water based coatings is heavily dependent on the amount of water present in the coating layer, a stable coating process is prerequisite for a stable drying process. In this study, we analyse the effect of different variables on the coating layer properties. We start by considering four critical variables identified in a previous study such as sand compaction, coating density, dipping time and gravity and then we add centre points to the original experimental plans to identify possible non-linear effects and variation in process stability. Finally, we investigate the relation between coating penetration (a variable that is relatively simple to measure in production) and other coating layer thickness properties (relevant for the drying process design). Correlations are found and equations are provided. In particular it is found that water thickness can be directly correlated to penetration with a simple linear equation and without the need to account for other variables.
Przejdź do artykułu

Ta strona wykorzystuje pliki 'cookies'. Więcej informacji