Reverberant responses are widely used to characterize acoustic properties of rooms, such as the early decay time (EDT) and the reverberation times T20 and T30. However, in real conditions a sound decay is often deformed by background noise, thus a precise evaluation of decay times from noisy room responses is the main problem. In this paper this issue is examined by means of numerical method where the decay times are estimated from the decay function that has been determined by nonlinear polynomial regression from a pressure envelope obtained via the discrete Hilbert transform. In numerical experiment the room responses were obtained from simulations of a sound decay for two-room coupled system. Calculation results have shown that background noise slightly affects the evaluation of reverberation times T20 and T30 as long as the signal-to-noise ratio (SNR) is not smaller than about 25 and 35 dB, respectively. However, when the SNR is close to about 20 and 30 dB, high overestimation of these times may occur as a result of bending up of the decay curve during the late decay.
The increasingly stringent requirements for wastewater treatment enforce the adoption of technologies that reduce pol-lution and minimize waste production. By combining the typical activated sludge process with membrane filtration, biolog-ical membrane reactors (MBR) offer great technological potential in this respect. The paper presents the principles and ef-fectiveness of using an MBR at the Głogów Małopolski operation.Physicochemical tests of raw and treated wastewater as well as microscopic analyses with the use of the FISH (fluorescence in situ hybridization) method were carried out. More-over, the level of electric energy consumption during the operation of the wastewater treatment plant and problems related to fouling were also discussed. A wastewater quality analysis confirmed the high efficiency of removing organic impurities (on average 96% in case of BOD5 and 94% in case of COD) and suspension (on average 93%).
The article discusses tests concerning the assessment of the corrosion resistance, properties and the structure of TIG braze welded galvanised steel sheets. Test butt joints were made of 0.9 mm thick galvanised car body steel sheets DC04 (in accordance with EN 10130), using a robotic welding station and a CuSi3Mn1 braze (in accordance with PN-EN 13347:2003) wire having a diameter of 1.0 mm. The research-related tests aimed to optimise braze welding parameters and the width of the brazing gap. The test joints were subjected to visual tests, macro and microscopic metallographic tests, hardness measurements as well as tensile and bend tests. The corrosion resistance of the joints was identified using the galvanostatic method. The tests revealed that it is possible to obtain high quality joints made of galvanised car body steel sheets using the TIG braze welding process, the CuSi3Mn1 braze and a brazing gap, the width of which should be restricted within the range of 0.4 mm to 0.7 mm. In addition, the joints made using the aforesaid parameters are characterised by high mechanical properties. The minimum recommended heat input during process, indispensable for the obtainment of the appropriate spreadability of the weld deposit should be restricted within the range of 50 kJ/mm to 70 kJ/mm. At the same time, the aforesaid heat input ensures the minimum evaporation of zinc. Joints made using the TIG braze welding method are characterised by high resistance to electrochemical corrosion. The galvanostatic tests did not reveal any traces of corrosion in the joint area.
Studies conducted between December 20. 1978 and February 20. 1979 on Arctowski Station show that daily sums of total radiation ranged from 165.5 to 834.5 mWhr x cm2. Maximal mean hourly radiations were recorded from 12 to 14 hours (39.7—72.4 mWhr x cm2).
en
pl
