Changes in capacity of water reservoir Cedzyna during its exploitation since 1972 till 2003 are presented in the paper. Analyses were based on cross sections of the reservoir’s basin from before its fulfillment (1967) and those measured with the echo sounder Ceeducer in 2003. Silting of reser-voir was predicted based on empirical methods. The volume of reservoir was found to decrease by 112.8 thousand m3 during 31 years of its exploitation and reservoir’s life span was assessed at 685 years. An error analysis was additionally made of calculating the surface area of a cross section at varying number of sounding sites. It was found that there was no need to note too many coordinates and depths and for the Cedzyna reservoir the distance between measurement sites up to 16 m was sufficient.

The calculations of fuel tanks should take into account the geometric imperfections of the structure as well as the variability of the material parameters of the foundation. The deformation of the tank shell can have a significant impact on the limit state of the structure and its operating conditions. The paper presents a probabilistic analysis of a vertical-axis, floating-roof cylindrical shell of a tank with a capacity of 50000 m3 placed on stratified soil with heterogeneous material parameters. The impact of a random subsoil description was estimated using the Point Estimated Method (PEM). In this way, the number of analyzed FEM models was significantly reduced. This approach also makes it possible to assess the sensitivity of tank settlement and deformation to the changing foundation conditions.

Fuel tanks are designed with regard to standard loads and operating conditions. The investigations of the paper show the impact of such factors as tank corrosion and other means on variation of stress fields and deformation of the underground horizontal tank shell. Introduction of probabilistic methods allows for structural reliability assessment. While the computational time of the entire tank FEM model is high the preliminary analysis is restricted to structural part only. The analysis makes it possible to optimize the structure with regard to construction costs.

The paper presents the results of laboratory tests of SCB (semi-circular beam) samples of asphalt concrete, subjected to the destructive effect of water and frost as well as the aging processes. The determined values of material parameters show significant dispersions, which makes the design of mixtures difficult. Statistical analysis of the test results supplemented by computer simulations made with the use of the proprietary FEM model was carried out. The main distinguishing feature of the model is the assignment of material parameters of coarse aggregate and bituminous mortar to randomly selected finite elements. The parameters of the mortar are selected by trial and error to match the numerical results to the experimental ones. The stiffness modulus of the bituminous mortar is, therefore, a substitute parameter, taking into account the influence of many factors, including material degradation resulting from the aging and changing environmental conditions, the influence of voids, and contact between the aggregate and the bituminous mortar. The use of the Monte Carlo method allows to reflect the scattering of the results obtained based on laboratory tests. The computational algorithm created in the ABAQUS was limited only to the analysis of the global mechanical bending response of the SCB sample, without mapping the failure process in detail. The combination of the results of laboratory tests usually carried out on a limited number of samples and numerical simulations provide a sufficiently large population of data to carry out a reliable statistical analysis, and to estimate the reliability of the material designed.