In general, currently employed vehicle classification algorithms based on the magnetic signature can distinguish among only a few vehicle classes. The work presents a new approach to this problem. A set of characteristic parameters measurable from the magnetic signature and limits of their uncertainty intervals are determined independently for each predefined class. The source of information on the vehicle parameters is its magnetic signature measured in a system that enables independent measurement of two signals, i.e. changes in the active and reactive component of the inductive loop impedance caused by a passing vehicle. These innovations result in high selective classification system, which utilizes over a dozen vehicle classes. The evaluation of the proposed approach was carried out for good vehicles consisting of 2-axle tractor and a 3-axle semi-trailer.

Measurement data obtained from Weigh-in-Motion systems support protection of road pavements from the adverse phenomenon of vehicle overloading. For this protection to be effective, WIM systems must be accurate and obtain a certificate of metrological legalization. Unfortunately there is no legal standard for accuracy assessment of Weigh-in-Motion (WIM) systems. Due to the international range of road transport, it is necessary to standardize methods and criteria applied for assessing such systems’ accuracy. In our paper we present two methods of determining accuracy of WIM systems. Both are based on the population of weighing errors determined experimentally during system testing. The first method is called a reliability characteristic and was developed by the authors. The second method is based on determining boundaries of the tolerance interval for weighing errors. Properties of both methods were assessed on the basis of simulation studies as well as experimental results obtained from a 16-sensor WIM system.

Paper deals with the new localizer GLOP2 designed for detection of the miners trapped in underground hard coal mines. The results of a field test conducted in coal mine BOBREK show that the presented localizer allows for efficient measurement of the distance between a trapped miner and the rescuer in the range of up to 15 m.

The paper provides analysis of the influence of temperature on the error of weigh-in-motion (WIM) systems utilizing piezoelectric polymer load sensors. Results of tests of these sensors in a climatic chamber, as well as results of long-term tests at the WIM site, are presented. Different methods for correction of the influence of changes in temperature were assessed for their effectiveness and compared.

Minimally invasive procedures for the kidney tumour removal require a 3D visualization of topological relations between kidney, cancer, the pelvicalyceal system and the renal vascular tree. In this paper, a novel methodology of the pelvicalyceal system segmentation is presented. It consists of four following steps: ROI designation, automatic threshold calculation for binarization (approximation of the histogram image data with three exponential functions), automatic extraction of the pelvicalyceal system parts and segmentation by the Locally Adaptive Region Growing algorithm. The proposed method was applied successfully on the Computed Tomography database consisting of 48 kidneys both healthy and cancer affected. The quantitative evaluation (comparison to manual segmentation) and visual assessment proved its effectiveness. The Dice Coefficient of Similarity is equal to 0.871 ± 0.060 and the average Hausdorff distance 0.46 ± 0.36 mm. Additionally, to provide a reliable assessment of the proposed method, it was compared with three other methods. The proposed method is robust regardless of the image acquisition mode, spatial resolution and range of image values. The same framework may be applied to further medical applications beyond preoperative planning for partial nephrectomy enabling to visually assess and to measure the pelvicalyceal system by medical doctors.

Systems of road traffic parameters measurement play a key role in the process of road traffic control, its supervision as well as in gathering and processing information for statistical purposes. Expectations of users of such systems mainly concern automation and provision of measurement continuity, possibility of selection of the measured road traffic parameters and high accuracy along with reliability of obtained results. In order to meet the requirements set for such systems, at the Department of Instrumentation and Measurement of the AGH University of Science and Technology in Cracow a new prototype system of road traffic parameters measurement - Traffic-1 - has been constructed. The innovativeness of the solution is manifested in the structure of the system that can be modified by the user adequately to current measurement needs and in the used algorithms of signals processing. The work contains a brief description of the constructed system with particular focus on the used innovations that are the result of many years of research work of the designers.