The microstructures and mechanical properties of T92 martensitic steel/Super304 austenitic steel weld joints with three welding consumables were investigated. Three types of welding materials ERNiCr-3, ERNiCrCoMo-1and T-304H were utilized to obtain dissimilar welds by using gas tungsten arc weld (GTAW). The results show that heat affect zone (HAZ) of T92 steel consists of coarse-grained and fine-grained tempered martensites. The microstructures of joints produced from ERNiCrCoMo-1 consist of equiaxed dendrite and columnar dendrite grains, which are more complicated than that of ERNiCr-3. In the tensile tests, joints constructed from ERNiCrCoMo-1 and T-304H met the ASME standard. The highest fracture energy was observed in specimens with the welding material ERNiCrCoMo-1. Ni content in weld seam of ERNiCrCoMo-1 was highest, which was above 40%. In conclusion, the nickel alloy ERNiCrCoMo-1 was the most suitable welding material for joints produced from T92 martensitic steel/Super304 austenitic steel.

Fusion welding of Ti-Cu is difficult because of big difference of melting points and formation of brittle intermetallic compounds. Friction stir welding is carried out by solid-state joining, thermo-mechanical stirring, and friction heat. Ti-Cu FSW dissimilar welding can supply a very sound joint area with a few intermetallic compounds. Optimized welding process conditions are essential to obtain suitable microstructure and mechanical properties of welded zones. Different welding speeds affect the evolution of microstructure and mechanical properties due to changes of input heat and internal stored deformation energy. The correlation of microstructure and mechanical properties of Ti-Cu welded zone according to welding speeds were investigated and analyzed. As the higher the welding speed, the lower the heat input and the lower the temperature rise. Ti-Cu 75 has the smallest grain size at 13.9 μm, but the optimum mechanical properties and the integrity of welding were shown in Ti-Cu 50.