This study presents an analysis of aluminium cast iron structure (as-cast condition) which are used in high temperatures. While producing casts of aluminium iron, the major influence has been to preserve the structure of the technological process parameters. The addition of V, Ti, Cr to an Fe-C-Al alloy leads to the improvement of functional and mechanical cast qualities. In this study, a method was investigated to eliminate the presence of undesirable Al4C3 phases in an aluminium cast iron structure and thereby improve the production process. V and Ti additions to aluminium cast iron allow the development of FeAl - VC or TiC alloys. In particular, V or Ti contents above 5 wt.% were found to totally eliminate the presence of Al4C3. In addition, preliminary work indicates that the alloy with the FeAl - VC or TiC structure reveals high oxidation resistance. The introduction of 5 wt.% chromium to aluminium cast iron strengthened the Al4C3 precipitate. Thus, the resultant alloy can be considered an intermetallic FeAl matrix strengthened by VC and TiC or modified Al4C3 reinforcements.
In this investigation the surface of an aluminized sample of plain carbon steel was melted and alloyed using a tingsten inert gas (TIG) welding process to produce iron-aluminide intermetallic phases on the surface. The produced coating was then characterized by SEM and EDS and its high-temperature properties in O2 + 1%SO2 gas were examined. The results showed that the Fe3Al coating produced could protect the substrate as it was subjected to the corroding gases at 700oC due to the formation of an alumina layer between the substrate and an outer layer of Fe2O3. At 900oC, the coating could only protect the substrate for 64 h. The lack of further protection at this temperature is attributed to the decrease in the protective properties of alumina with an increase in its temperature and the lack of presence of enough Al atoms in the coating for the repair of the defects formed in the alumina layer.