Wire and laser additive manufacturing (WLAM) can produce outstanding mechanical properties of GH3039 nickel-based superalloys. A quantitative rapid phase field model with solute trapping kinetics has been developed during the rapid solidification process, where a range of process conditions are considered in terms of thermal gradients and pulling speeds. Intergranular hot cracking is found to occur at boundaries of tilted columnar dendrite in the GH3039 nickel-based superalloys. The simulations demonstrate that the phase field model considering the interface deflection can represent the dendrite growth during additive manufacturing more realistically. With the aid of numerical simulations, it is determined that dendrite growth morphologies transform from symmetrical columnar dendrite to tilted columnar dendrite as the interface crystallographic deflection is increased, while increasing the deflection angle can lead to uneven composition of material matrix, especially at the columnar dendrite interface. Solute concentrations at the columnar dendrite interface tend to promote hot cracking in additively manufactured Ni-based superalloy.

Article presents results of laser overlaying welding of metal powder Inconel 625. Laser metal deposition by laser engineered net shaping (LENS) is modern manufacturing process for low scale production series. High alloy materials such as Inconel 625 nickel based super alloy have high thermal resistant and good mechanical properties, nevertheless it's hard to machining. Plastic forming of high alloy materials such as Inconel 625 are difficult. Due to high strength characteristic performing components made from Inconel alloy are complex, selective melting of metallic powder using laser beam are alternative method for Inconel tooling. Paper present research of additive deposition of spatial structure made from Inconel 625 metallic powder with CO2 laser and integrated powder feeder. Microstructure analysis as well as strength characteristic in normal condition and at elevated temperature was performed. Possibility of using LENS technology for manufacturing components dedicated for work in high temperature conditions are presented.

Tilted columnar dendritic morphologies are usually existed in wire and laser additive manufactured parts of GH3039 alloy. Overgrowth behaviors induced by the tilted dendritic arrays with a large tilted angle, and the effect of the angle between the growth direction and the direction vertical locally to the solid substrate on primary spacing, solute concentration and morphological evolution have been investigated at both the converging and the diverging grain boundaries through the phase-field simulation. The formation of cracking depends on solidification behaviors including columnar dendrites growth and micro-segregation in the interdendritic region. Furthermore, the effect of the tilted columnar dendrites on the susceptibility of crack is investigated during wire and laser additive manufacturing.