Number of trace compounds (called biomarkers), which occur in human breath, provide an information about individual feature of the body, as well as on the state of its health. In this paper we present the results of experiments about detection of certain biomarkers using laser absorption spectroscopy methods of high sensitivity. For NO, OCS, C₂H₆, NH₃, CH₄, CO and CO(CH₃)₂ an analysis of the absorption spectra was performed. The influence of interferents contained in exhaled air was considered. Optimal wavelengths of the detection were found and the solutions of the sensors, as well as the obtained results were presented. For majority of the compounds mentioned above the detection limits applicable for medicine were achieved. The experiments showed that the selected optoelectronic techniques can be applied for screening devices providing early diseases detection.

Widely-tunable, fully-monolithic, mid-infrared (mid-IR) deference frequency generation source (DFG) is presented. By using a custom designed fiber-pigtailed periodically poled lithium niobate (PPLN) crystal module the idler beam was generated with an efficiency of 21%/W, yielding 2.6 mW of optical output power. The proposed all-fiber configuration radically simplified the optical frequency conversion setup, making it robust and easily configurable. The usefulness of the constructed source was verified by performing simultaneous wavelength modulation spectroscopy (WMS) laser trace gas detection of methane, near 2999 cm⁻¹, and ethane, near 2997 cm⁻¹, via two independently generated, tunable idler beams.

A method for frequency-multiplexed multi-sample gas sensing is presented. It enables measuring multiple samples placed simultaneously in the setup, without any optical or mechanical switching. Samples are measured using heterodyne detection and signal from each sensing path is encoded at different carrier frequency. Subsequently, a signal from particular sample is retrieved through heterodyne beatnote demodulation at unique frequency. This technique is particularly suitable for real-time calibration of the sensor through a sequential (or simultaneous) detection of three signals: from unknown sample, reference sample and baseline. Basic setup is demonstrated and proof-of-concept experiments are presented. Very good agreement with spectra measured using standard tunable diode absorption spectroscopy is obtained.