Development of the transport infrastructure in Poland has contributed to the implementation of various technologies of construction of bridges and their components. Use of reinforced soil for construction of embankments, retaining structures (RSS walls) and abutments is one of the solutions which has been frequently used for the past twenty years. Shortly after its development, the technology proposed by Henri Vidal in 1966 also gained appreciation in Poland [4]. Reinforced soil bridge abutments started to be widely used in Poland at the turn of the 20th century. The bridge facilities at the junction of Trasa Siekierkowska route and Wał Miedzeszyński Street in Warsaw, which were built in the years 2000÷2002, are an example of structures from that period. The authors of this paper have been particularly interested in the outermost supports of the reinforced concrete flyovers which were constructed in the form of intermediate reinforced soil abutments. Offsets – the vertical displacements, in the range of 15÷25mm, emerging between the level of the road surface and the steel elements of the expansion joints which separate the flyover’s structure from the embankment – were observed in 2015, in the course of regular inspections. While accounting for the observations which have been made, the surveying measurements and the ground investigation, the paper diagnoses and describes the mechanism which led to the emergence of the offsets. Potential patterns of the occurrence of additional settlements, as the reason for emergence of the offsets, were identified and analyzed. The settlement of the outermost support (abutment), as a result of increase of relative density of alluvial sands due to the dynamic interaction of the roadways of Wał Miedzeszyński Street, was analyzed. Analytical and numeric approaches were used in the course of analysis while relying on PLAXIS and MIDAS software.

Failures that occurred in the last few decades highlighted the need to raise awareness about the emergent risk related to the impact localised degradation phenomena have on embankments. Common interventions aimed to improve embankments, such as the reconstruction of the damaged area or the injection of low-pressure grouts to fill fractures and burrows, may cause the weakening of the structure due to discontinuities between natural and treated zones. Moreover, since such repair techniques require huge volumes of materials, more sustainable solutions are encouraged. At the same time, the textile and fashion industries are looking for sustainable waste management and disposal strategies to face environmental problems concerned with the voluminous textile waste dispatched to landfills or incinerators. The use of soil mixed with textile waste in embankment improvement has been investigated to identify an effective engineering practice and to provide a strategy for the circular economy of textiles. Preliminary laboratory tests have been conducted on soil specimens collected from the Secchia River embankment, Northern Italy, to define the appropriate mixture proportions and to compare physical properties and hydro-mechanical behaviour of natural and treated soils. The results show that an appropriate fibre content offers manageable and relatively homogeneous mixtures. The indluence on soil consistency is mainly due to the textile fibre hydrophilic nature. The addition of fibres reduces the maximum dry density and increases the optimum water content. At low stress levels, the compressibility and hydraulic conductivity appear higher, however macro voids produced during sample preparation may alter the findings.