The aim of this research was to experimentally analyse the possibility of using a rubber hose placed inside a pipeline to mitigate the water hammer phenomenon. The experiments were conducted using a steel pipeline with an inner diameter of 53 mm and an EPDM rubber hose with a diameter of 6 mm. Hydraulic transients were induced by a rapid closure of the valve located at the downstream end of the pipeline system. In order to analyse the influence of steady-state flow conditions on the maximum pressure increase, measurements were carried out for different values of initial pressure and discharge. The experimental results indicate that placing a rubber hose inside a pipeline can substantially attenuate valve-induced pressure oscillations. It was observed that the initial pressure has a significant influence on the capacity of the rubber hose to dampen the water hammer phenomenon. Comparative numerical calculations were performed using the Brunone–Vitkovský instant acceleration-based model of unsteady friction. It was demonstrated that this approach does not allow satisfactory reproduction of the observed pressure oscillations due to the viscoelastic properties of the EPDM hose used in the tests.

This paper investigated the problems and impacts of transient flow in pipeline systems due to pump power failure. The impact of different protection devices was presented to assure surge protection for the pipeline system. A model via Bent-ley HAMMER V8.0 Edition was employed to analyse and simulate hydraulic transients in the pipeline system, and protec-tion alternatives were studied.

Surge protection included using only an air vessel, using an air vessel and two surge tanks, and employing five air ves-sels and vacuum breaker. The obtained results for pressures, heads, and cavitation along the pipeline system were graph-ically presented for various operating conditions. Using five air vessels with vacuum breaker valve as surge protection proved to be more effective and economical against pump power failure.

Changing the flow density did not have a significant impact on the pressures.

For protection with an air vessel; it was concluded that the value 40% of the original diameter for inlet pipe diameter of air vessel, and the value of 2/3 of original pipe diameter were critical values for the transient pressures. Cast iron pipes proved to be the best pipe material for all studied volumes of the air vessel.

For protection with an air vessel and two surge tanks; as the inlet pipe diameters increased the maximum pressures in-creased and the minimum pressures decreased.

Regression analyses were performed obtaining equations to predict the pressures according to the inlet pipe diameter, the area of surge tank, and the pipe diameter.