In this paper, the authors investigated the size distribution of titanium oxide (TiO2), titanium nitride (TiN) and titanium carbide (TiC) inclusions in a titanium deoxidized 4130 steel and compared it with the 4130 base alloy composition inclusions. TiN and TiC inclusions are of particular interest due to their role as heterogeneous nuclei for various phase reactions in steels. Two types of samples were prepared, a polished sample and a filtered sample. Electrolytic dissolution was employed to make the filter paper samples. The size range of titanium inclusions was found to be more than that of the non-metallic inclusions from 4130 base alloy heat. Titanium inclusions from the filter and polished samples were round in shape. TiC and TiN inclusions were not found in the electrolytic extraction samples. Inclusions and their chemistries were analyzed using scanning electron microscope and energy dispersive spectrometer. The inclusion size range was larger for the titanium deoxidized samples than the base alloy. However, in both steels the majority of inclusions had a size smaller than 10 μm.
The role of slag in the process of continuous casting of steel (CCS) is reduced to the thermal and chemical insulation of the liquid steel surface, and additionally to refining. The ability to adsorb non-metallic inclusions flowing off from the crystallizer, mainly Al2O3, determines its physicochemical properties. As a result of adsorption and dissolution of inclusions tin he liquid layer the viscosity and thickness of mould flux change, which eventually affects the technological parameters and behavior of slag in the crystallizer. The influence of aluminum oxide on the viscosity of slag was empirically investigated with a structural viscosity model worked out by Nakamoto. The results of the simulation are presented in the form of plots. Authors observed a significant influence of Al2O3 on the slag viscosity, which suggests that this effect should be taken into account when selecting chemical composition of mould flux for definite types of steel. The results of calculations also show that the disturbances in casting caused by the use of the mould slag may be connected with the content of non-metallic inclusions in steel.
Plant viruses create many changes in the morphology of the plant cell once the infection process has begun. This paper describes and compares the ultrastructural changes induced in maize cells by two isolates of Maize dwarfmosaic virus (MDMV), Spanish (MDMV-Sp) and Polish (MDMV-P), and one isolate of Sugarcane mosaic virus (SCMV) at 10 and 42 days post-inoculation: the concentration and arrangement of virus particles, inclusion bodies associated with infection, and other cytological alterations. The most important difference between maize cells infected with MDMV isolates and with SCMV-P1 was in the form of cytoplasmic cylindrical inclusions. In cells infected with MDMV only typical inclusions such as pinwheels and scrolls were observed, but laminar aggregates were also present in SCMV-infected cells. No virus particles were found in plant cell organelles. Specific virion arrangements occurred in cells infected with MDMV-Sp and SCMV. The most interesting new finding was of specific amorphous inclusions in the cytoplasm of MDMV-Sp-infected cells, which clearly differentiated the two MDMV isolates studied.
Filtration is one of the most efficient methods of removing Al2O3 inclusions from liquid steel. The efficiency of this process depends on the physicochemical parameters of liquid metal, inclusion and properties of the applied filters. The particles attracted during filtration undergo agglomeration, collisions and chemical reactions on the filter surface, with the emphasis on the mechanism of particle collisions and the role of material from which the filter was made. The aluminum oxide inclusions collide with the filter surface and as the growing process continues, the particles also collide with the previously adsorbed inclusions. At the interface of particle and filter the mixing of the metal bath is most intense, being a result of a sudden change of flow direction and breaking up the stream of liquid metal which is in a direct contact with material. The efficiency of filtration is defined not only by the behavior of individual particles but of all population. The simulations revealed that only a small fraction of these particles adheres directly to the filter material; most of them stick to the former ones. Attention should be also paid to the fact that some of the inclusions which contacted the filter walls do not form a permanent connection and are then entrained by metal. Authors solved the problem of agglomeration and collisions of Al2O3 inclusions with the ceramic surface of the filter with the PSG method, mainly used for the analysis of agglomeration of inclusions during steel refining in the ladle.
The study consists of three parts. The first comprises the characteristic features of social politics strategy. They include the basic assumptions and functions of the social politics strategy in the field of the development of education and aid activities at the level of local units of territorial authorities. The essence of the study is the second part. It consists of the own research results – an analysis of the aims and tasks associated with inclusive education (also with preparing local communities for creating inclusive culture), comprised in strategies. The whole is completed with final conclusions. The study is aimed at the qualitative analysis of the development strategy of 17 communes (3900 pages of documents) as regards the issues of disability. The research interest was to find out whether the slogans promoting the equal access to education, elimination of barriers and preparing mainstream schools and local community for inclusive culture had been reflected in any way in the social politics strategies of local authorities – in the documents which, at least in the assumptions, constitute the starting point for generating good practices, also in the field of social support and education for disabled learners.
Results from broadband acoustical spectroscopy for aqueous solutions of mono- and disaccharides with salts added, of various alkyl glycosides, and of α-cyclodextrin with n-octyl-β-D-glucopyranoside added are briefly summarized in view of their relevance in the study of molecular association and complexation processes. Mono- and tridentate complexes of alkali earth ions with saccharides are discussed as well as the monomer exchange between micellar structures and the suspending phase in the alkyl glycoside surfactant solutions. Particular attention is given to the behaviour at solute concentrations close to the critical micelle concentration or aggregate concentration, respectively. Also described is the competition between inclusion complex formation and self-aggregation in solutions containing cyclodextrin and alkyl glycoside surfactant.
The removal of inclusions is a major challenge prior to the casting process, as they cause a discontinuity in the cast material, thereby lowering its mechanical properties and have a negative impact on the feeding capability and fluidity of the liquid alloys. In order to achieve adequate melt quality for casting, it is important to clean the melts from inclusions, for which there are numerous methods that can be used. In the course of the presented research, the inclusion removal efficiency of rotary degassing coupled with the addition of different fluxes was investigated. The effects of various cleaning fluxes on the inclusion content and the susceptibility to pore formation were compared by the investigation of K-mold samples and the evaluation of Density Index values at different stages of melt preparation. The chemical composition of the applied fluxes was characterized by X-ray powder diffraction, while the melting temperature of the fluxes was evaluated by derivatographic measurements. It was found that only the solute hydrogen content of the liquid metal could be significantly reduced during the melt treatments, however, better inclusion removal efficiency could be achieved with fluxes that have a low melting temperature.
The smart city concept is constantly evolving. More and researchers in Poland and also in the whole world deal with this issue. In practice, it is noted that in cities around the world you can find more and more implemented projects referred as smart, in particular in Barcelona, Vienna and Copenhagen and others. According to the classical definition, smart city means introducing solutions based on the latest information technologies to urban spaces in order to improve the quality of life of city residents. Smart city is a city concept in which solutions can solve the most important problems related to the functioning of cities, such as improvements in public transport and goods in cities, counteracting climate change through the use of energy-saving solutions of city lighting, social inclusion (access city) and others. The concept of smart city is based on IT solutions that are constantly modernized and adapted to specific needs of individual cities. By using real-time access to information, they help make more efficient decisions for city users. However, recent approaches highlight the relationship between modern network technologies and the urban community. One can notice the focus of the researchers on the relational approach, which means combining the smart city concept with the participation of residents in the city management process, and in particular making choices and implementing smart projects. In this sense, the smart city idea defines the way of managing a city in which relations between the self-government, IT providers and science as well as the inhabitants of the city are particularly important. Responding to the needs of residents is particularly important as counteracting the tendency to focus smart products and services in richer places and create socalled an innovation hub with the simultaneous periphery of the remaining districts. Criticism of the smart city concept focuses on the problem of the social polarization of cities, in which the technological revolution contributes more to the increase of socio-economic disparities rather than their decreasing. The aim of the article is to answer the question whether the implementation of the smart city concept polarizes the urban community and does it allow the inclusive development of cities?
The contemporary world is marked by clear disproportions in terms of living, working and wage. This problem also applies to Poland, including the layout designated by cities. The quantitative analysis carried out proves that the identified disproportions in the development potential have a relatively permanent character, which gives them structural attribute. In this context, the desirable effectiveness of development policy (subordinate to the vision and funds of EU cohesion policy) becomes highly questionable. Today’s economic inclusion is a serious challenge to the failure of recognized development policies. The shaping of the socio-economic order of the state requires a new look at local development, starting from a reliable diagnosis, part of which is this study, to bold and real visions.
Celestine is a rather common mineral in epigenetic native sulphur deposits and seems to be a very valuable
indicator of some of the geological processes forming these deposits. This paper presents the results of investigation
of fluid inclusions in celestine from the Tarnobrzeg native sulphur deposits (SE Poland). Several different
morphological types of celestine were selected from Machów open-pit mine. Study of the fluid inclusions has
been carried out using microscopic and microthermometic methods. The data show that two types of chloride
fluids were responsible for the formation of celestine and native sulphur and further transformation of the native
sulphur deposits. The first type of fluid, containing a relatively higher salt content and lower NaCl/CaCl2 ratio,
also points to the role of hydrocarbons during the formation of native sulphur deposits. The second type of fluid
contains a relatively lower amount of salt and a higher NaCl/CaCl2 proportion and reflects the subsequent evolution
of the chemistry of the fluids forming the deposits. The results of the study of fluid inclusions in celestine
are in good agreement with its stable isotope composition.
en
pl
